RAID5 on two disks

By -

When recovering data from a client's NETGEAR ReadyNAS device we saw a rather strange layout - RAID5 of two disks, which appeared once ReclaiMe File Recovery has processed md-raid records. After looking at it for a while we realized that this is, surprisingly, possible given that we ignore the requirement of a minimum number of disks. So let's see what happens when placing data and parity blocks on two disks in a RAID5 layout where a stripe contains, say, three sectors:

Now let's see what are there in the parity blocks in such a layout? In order to get an even row of two elements it is needed that all the elements would be the same, so the content of the parity block is the same as the content of its corresponding data block. Therefore we deal with a typical RAID1 (mirror) layout. Despite all the wildness of the layout, it meets all the basic criteria of a RAID5:
  • survives a single disk failure,
  • the disk space overhead equals to the capacity of one member disk.
As far as data recovery goes, such a RAID5 layout is better than a typical one since it doesn't require the recovery of RAID configuration parameters should the md-raid setup fail. In this case it would be enough to get each disk in turn, recover data as in case of a regular hard drive recovery, compare the results, and chose the best.

Comments

  1. HDD Recovery Services4 January 2013 at 19:19

    seems like a shady setup to be honest. Why not just run a mirror?

    ReplyDelete
    Replies
    1. Geek II5 January 2013 at 06:20

      That was a NetGear ReadyNAS with its FlexRAID or whatever. I suppose they use this trick to simplify the online expansion when the disk is added.

      Delete

Post a Comment

Popular posts from this blog

QNAP revisited

By Geek -
For reference, we were using QNAP TS-639 Pro with six WD20EADS disks. After about half a year of use, the web-interface was running slower, so that we needed to wait for several minutes to obtain the list of the disks. Gradually, we noted that the array performance decreased significantly. It seemed obvious to assume that one of the member disks has been dropped from the array and a RAID5 was working in the degraded mode. However, all the member disks were marked as GOOD in the web-interface. It was suspicious that LEDs on the disk bays indicating the state and activity of the disks were blinking unevenly. Logically, for RAID5 one should expect almost symmetric load on the disks, but in fact, one of the disk LED was blinking much more frequently. Once we had run the bad blocks check on this disk through the web-interface, the disk dropped from the array in less than half an hour and its bay LED turned red. At this point, the web-interface began to work properly again. The disk taken fr
Read more

APFS Data Recovery

By -
Apple File System, APFS for short, is a brand-new filesystem released in 2017. The goal is to replace HFS+ which has been in use on Apple computers since 1998. Formally released in late 2017, APFS filesystem began to be used by default on Apple computers running under MacOS High Sierra. Among the main features of APFS filesystem are 64-bit pointers allowing to address 2^56 blocks More accurate created/accesses/modification time measured in nanoseconds since 1970-01-01 Copy-on-write Sharing blocks between APFS volumes Native full-disk encryption We are happy to announce that now ReclaiMe data recovery software is capable of recovering data from APFS-formatted devices be it a USB thumb drive, or external hard drive, or internal SSD boot drive. You can download the latest build of ReclaiMe at www.ReclaiMe.com .
Read more