Came across this, admittedly old, discussion about Storage Spaces http://www.eightforums.com/general-support/15887-storage-spaces-questions.html The fun starts at around post #4, with a real good piece of advice - your setting up a large drive system, read a LOT before committing your data to it for good. Then the discussion touches the Drive Extender briefly. Storage Spaces is not Drive Extender . Indeed it is not. Storage Spaces is arguably more fragile, and undoubtedly Storage Spaces is more difficult to recover once failed. Way more difficult, I'd venture to say. Then, around post #8, virtual machines come up. The common misconception is that recovery from storage system failures can be practiced with virtual machines. You'd better not. Virtual machines are good for modeling and training some normal operations of a storage system, but they are abysmal in reproducing storage behavior in failures. In a virtual machine, all hardware is fail-stop. You cannot simulate b
Showing posts from January, 2014
- Other Apps
Q: Once I have assembled RAID 5 with 5 disks of 1.5 TB in NAS QNAP, disks started to synchronize. 20 hours have passed but only 57% is done. Is this normal? It seems that array works OK (I have already copied data to it) A: It is typical, especially if the array is also busy with copying data. For large arrays, first synchronization or a full rebuild (after drive replacement) often takes several days. It is advisable not to copy user data to the array until the first synchronization is complete because the array does not still provide redundancy and fault tolerance.
- Other Apps
Q: I pulled the disks out of NAS QNAP to update firmware and then connected them back, but the NAS does not see nor does it initialize them. What should I do? A: Try to pull the disks out once again, return to the old firmware, and then put the disks back. If it works, try to update firmware without removing the disks. One part of the operating system inside QNAP is stored in the built-in NAS memory while the second part is on disks themselves. Mismatch between these two parts leads to NAS refusal to work with disks.